What commonly causes this problem with jerrycans?

Common causes include overfilling, over-application or excessive trim used as a safety margin; A change in dimensional and material variation or base stability and centre of gravity.; start-up and changeover settings not standardised.

How can I prove that an adjustment has worked for jerrycans?

Record a representative baseline, change one variable at a time and repeat the same measurement over enough packs to show that the result is stable rather than a one-off improvement.

When should I consider a different machine or production method for jerrycans?

Consider a different route when correct setup and maintenance cannot hold the required quality and sustained output across the complete product and pack range.

What information should I send before asking for a solution for jerrycans?

Include Dimensioned pack drawing; Minimum and maximum pack samples; Material and supplier specification; Closure or seal components.

Which solution website is most relevant to this question?

The clearest starting point on this page is Packaging Machines UK. Final suitability still needs to be confirmed using the actual product, packaging, output and site information.

Pack formats

How do I reduce damaged and rejected jerrycans?

Practical guidance for jerrycans: reduce product loss, damaged packs, film waste and avoidable rejects.

Answer format: direct explanation, ordered checks and relevant solution routes. Updated 4 August 2026. Application-specific engineering review is still required.

Direct answer

For jerrycans, measure where material or product is lost and calculate waste per good pack. A pack must remain clean, stable and correctly orientated through every transfer, filling, closing, labelling and inspection stage. Start by separate product, packaging and rework waste and record damage rate, jam rate, position repeatability and finished-pack integrity. Make one controlled change at a time so the original cause is not hidden by several new settings.

Packaging Machines UK

See the machinery and application options most closely matched to this production question.

View the solutionpackagingmachinesuk.co.uk

Production environment relevant to pack formats

Work safely: Isolate machinery before inspection or clearing. Follow the machine manual, site procedures and competent-person requirements.

What usually causes this?

overfilling, over-application or excessive trim used as a safety margin
A change in dimensional and material variation or base stability and centre of gravity.
start-up and changeover settings not standardised
The equipment or handling method not being set for larger handled containers requiring stable support and controlled filling.
damaged or misfed packaging creating repeated rejects

Checks to make in order

Separate product, packaging and rework waste
Record damage rate, jam rate, position repeatability and finished-pack integrity using a representative sample.
Weigh or count loss during start-up, running and changeover
Check neck, opening or sealing geometry, surface condition and static and guides, transfers and pack support.
Record the reason for every reject in a sample period
Check whether waste changes with speed or pack size
Calculate the financial value of giveaway and damaged packs

How to decide the next step

Jerrycans involves larger handled containers requiring stable support and controlled filling. Prioritise the largest measured loss, then verify that the change does not reduce seal, dose or closure quality.

If adjustment and maintenance cannot hold the required result across the complete product and pack range, compare the machinery route against a written acceptance test. The important comparison is sustained good output—not only maximum cycle speed.

What to include in your production brief

Supplying the information below makes it much easier to distinguish a setup problem from a machinery or packaging limitation:

Dimensioned pack drawing
Minimum and maximum pack samples
Material and supplier specification
Closure or seal components
Required orientation and label area
Target line rate
Samples that represent jerrycans
A short video of the current process and fault

Relevant solution websites

These specialist sites match the production process discussed above. Final suitability should be confirmed with samples, output, site and acceptance information.

Packaging Machines UK Packaging Lines StockPack