What commonly causes this problem with viscous liquids?

Common causes include overfilling, over-application or excessive trim used as a safety margin; A change in product temperature and viscosity or product supply pressure or level.; start-up and changeover settings not standardised.

How can I prove that an adjustment has worked for viscous liquids?

Record a representative baseline, change one variable at a time and repeat the same measurement over enough packs to show that the result is stable rather than a one-off improvement.

When should I consider a different machine or production method for viscous liquids?

Consider a different route when correct setup and maintenance cannot hold the required quality and sustained output across the complete product and pack range.

What information should I send before asking for a solution for viscous liquids?

Include Product formulation or safety data; Normal filling temperature; Minimum and maximum dose; Acceptable fill tolerance.

Which solution website is most relevant to this question?

The clearest starting point on this page is Paste Fillers. Final suitability still needs to be confirmed using the actual product, packaging, output and site information.

Liquid filling

How do I reduce drips, giveaway and waste when filling viscous liquids?

Practical guidance for viscous liquids: reduce product loss, damaged packs, film waste and avoidable rejects.

Answer format: direct explanation, ordered checks and relevant solution routes. Updated 4 August 2026. Application-specific engineering review is still required.

Direct answer

For viscous liquids, measure where material or product is lost and calculate waste per good pack. The result depends on product behaviour, supply conditions, dosing principle, nozzle design and container control. Start by separate product, packaging and rework waste and record measured fill weight or volume, cycle time and finished-pack leakage. Make one controlled change at a time so the original cause is not hidden by several new settings.

Paste Fillers

See the machinery and application options most closely matched to this production question.

View the solutionpastefillers.co.uk

Production environment relevant to liquid filling

Work safely: Isolate machinery before inspection or clearing. Follow the machine manual, site procedures and competent-person requirements.

What usually causes this?

overfilling, over-application or excessive trim used as a safety margin
A change in product temperature and viscosity or product supply pressure or level.
start-up and changeover settings not standardised
The equipment or handling method not being set for slow-moving products that need positive displacement and larger product paths.
damaged or misfed packaging creating repeated rejects

Checks to make in order

Separate product, packaging and rework waste
Record measured fill weight or volume, cycle time and finished-pack leakage using a representative sample.
Weigh or count loss during start-up, running and changeover
Check dosing chamber, pump or valve condition, nozzle position and shut-off and container location beneath the fill point.
Record the reason for every reject in a sample period
Check whether waste changes with speed or pack size
Calculate the financial value of giveaway and damaged packs

How to decide the next step

Viscous liquids involves slow-moving products that need positive displacement and larger product paths. Prioritise the largest measured loss, then verify that the change does not reduce seal, dose or closure quality.

If adjustment and maintenance cannot hold the required result across the complete product and pack range, compare the machinery route against a written acceptance test. The important comparison is sustained good output—not only maximum cycle speed.

What to include in your production brief

Supplying the information below makes it much easier to distinguish a setup problem from a machinery or packaging limitation:

Product formulation or safety data
Normal filling temperature
Minimum and maximum dose
Acceptable fill tolerance
Container and neck dimensions
Required good packs per hour
Samples that represent viscous liquids
A short video of the current process and fault

Relevant solution websites

These specialist sites match the production process discussed above. Final suitability should be confirmed with samples, output, site and acceptance information.

Paste Fillers Volumetric Fillers Automatic Filling Machines