What commonly causes product and pack compatibility with colour pigments?

Common causes include materials are selected from a generic description rather than the full formulation; pack drawings and normal dimensional variation are not available; temperature, pressure or storage changes material behaviour.

How can I prove that an adjustment has worked for colour pigments?

Record a representative baseline, change one variable, repeat the same measurement and compare enough good packs to show a stable improvement rather than a one-off result.

When should I consider different equipment for colour pigments?

Consider a different route when correct setup, suitable materials and planned maintenance cannot hold the required quality and sustained output across the complete range.

What information should I send before asking for a solution for colour pigments?

Include representative samples, dimensions, product behaviour, current method, required good output, acceptance tolerances, utilities and a video of the fault.

Which solution website is most relevant to this question?

The best-matched starting point is Auger Fillers at augerfillers.co.uk. The actual product, pack, output and site must still be reviewed.

Powder and piece filling

Which product-contact materials and packs are suitable for colour pigments?

Q: What should I check first for colour pigments?

Obtain full product, material and pack specifications.

Practical guidance for colour pigments: check materials, seals, adhesives, films, closures and product-contact parts.

Answer format: direct explanation, ordered checks and relevant solution routes. Updated 4 August 2026. Application-specific engineering review is still required.

Direct answer

For colour pigments, obtain full product, material and pack specifications before changing several settings at once. This is a dry-product application where bulk density, flow behaviour, dust, fragility, segregation and replenishment affect accurate dosing for colour pigments. Dust containment, hopper flow and bulk-density variation are central to repeatability.. Use representative product and packaging, keep the order of results and identify the first point where the process moves outside the agreed limit. Then make one controlled change, repeat the same test and compare sustained good output rather than a single successful pack.

Auger Fillers

Auger dosing for fine, dusty and non-free-flowing powders.

View the solutionaugerfillers.co.uk

Production environment relevant to colour pigments

Work safely: Isolate machinery before inspection or clearing. Follow the machine manual, site procedures and competent-person requirements.

What usually causes this?

materials are selected from a generic description rather than the full formulation
pack drawings and normal dimensional variation are not available
temperature, pressure or storage changes material behaviour
adhesives, liners, seals or coatings are tested separately rather than as a complete pack
the equipment or method is not configured for a dry-product application where bulk density, flow behaviour, dust, fragility, segregation and replenishment affect accurate dosing for colour pigments. Dust containment, hopper flow and bulk-density variation are central to repeatability.

Checks to make in order

Obtain full product, material and pack specifications
Review every wetted or contacting component
Test at normal and worst-case temperature
Use representative production batches
Inspect swelling, cracking, adhesion, seal and migration effects
Run the complete pack through storage and transport
Record written approval and limitations

How to decide the next step

Colour pigments is a dry-product application where bulk density, flow behaviour, dust, fragility, segregation and replenishment affect accurate dosing for colour pigments. Dust containment, hopper flow and bulk-density variation are central to repeatability.. Use the measurements to decide whether the next action is a material or packaging change, a setting correction, a maintenance task, improved feeding or a different machinery principle.

If the process cannot achieve the required product and pack compatibility result across the full product and pack range, compare the best-matched route against a written acceptance test. Include cleaning, changeover, operator work, rejects and recovery from normal stops.

What to include in your production brief

Supplying the information below makes it easier to distinguish a setup problem from a product, packaging, feeding, maintenance or machinery limitation: